Air-ConditionersPLA-RP·BA SeriesPLA-ZRP·BA SeriesEnglishDeutschFrançaisNederlandsEspañolItalianoPortuguêsDanskSvenskaINSTALLATION MANUALFor safe and c
105) Assigning a remote controller to each unit (Fig. 6-8)Each unit can be operated only by the assigned remote controller.Make sure each pair of an
116. Electrical workFunction tableSelect unit number 00Mode Settings Mode no. Setting no.Initial settingsettingPower failure automatic recovery Not a
12Changes the selection(No.).Unit No."1-4"Refrigerant address No."00-15"Outlet No."1-4"or "0"Up/Down air direc
13As for this air conditioner, air conditioner No. is "unit No. 1" ofrefrigerant address "0".Flow of procedureRefrigerantaddressNo
147. Test run7.1. Before test run► After completing installation and the wiring and piping of the indoor and outdoor units, check for refrigerant lea
157. Test runOPERATION INDICATOR lamp blinking patternBeep Beep Beep Beep Beep Beep BeepOffApprox. 2.5 sec.OnApprox. 3 sec.On0.5 sec.On0.5 sec.On0.5
167. Test runWater supply pumpWater (about 1000cc)Drain plugPour water through outlet · Be careful not to spray water into the drain pu
179.1. Checking the contents (Fig. 9-1)• This kit contains this manual and the following parts.Accessory name Q’ty Remarks1Grille 1 950 × 950 (mm)2Sc
189. Installing the grilleFig. 9-6A CeilingB Main unitC GrilleD Make sure that there are no gaps.E Adjust the nut of the main unit using a wrench, e
19(1) Press the TEST button for 3 seconds toactivate the maintenance mode.(2) Press the TEMP. buttons to set the refrigerant address.MAINTENANCE(3) S
2► Before installing the unit, make sure you read all the “Safety precau-tions”.► Please report to your supply authority or obtain their consent befor
Please be sure to put the contact address/telephone number on this manual before handing it to the customer.This product is designed and intended for
32. Installation locationRefer to the outdoor unit installation manual.3. Installing the indoor unitFig. 3-1Fig. 3-2Fig. 3-315016016016016090860-910
43. Installing the indoor unit3.4. Branch duct hole and fresh air intake hole (Fig. 3-4)At the time of installation, use the duct holes (cut out) lo
54. Installing the refrigerant piping4.1. Precautions For devices that use R410A refrigerant• Use ester oil, ether oil or alkylbenzene oil (small a
64.3. Indoor unit (Fig. 4-3)Heat insulation for refrigerant pipes:1 Wrap the enclosed large-sized pipe cover around the gas pipe, making sure that t
76. Electrical work6.1. Indoor unit (Fig. 6-1)1. Remove the electrical wiring service panel.2. Remove the electrical box cover.3. Wire the power c
8S1S2S3LNBLUEBLUEYELLOWYELLOWCN01CN01BLACKCN01BLACKS1S2S3LNYELLOWBLUEBLUEYELLOWCN016. Electrical work6.1.2. Separate indoor unit/outdoor unit power
96. Electrical work6.2. Remote controller6.2.1. For wired remote controller1) Installing procedures(1) Select an installing position for the remote
Kommentare zu diesen Handbüchern